Power amplifiers mono

The discrete bipolar design is unique and uses Power Dynamic Link power to instantly deliver 500W effortlessly over the entire frequency range.

Klimax Solo 800 high-performance power amplifier, which has received a unique offset technology. It can be used to set the optimal bias current for each of the sixteen output transistors in real time. Next, the bias currents are gradually adjusted and cross-distortion is eliminated throughout the life of the amplifier.

The Timekeeper series of amplifiers has been in development at Burson Audio for over fifteen years. The latest Voyager model is designed to operate at high idle current, allowing the transistors to operate in their most linear range, thereby minimizing distortion. Despite consuming over 100 watts in standby mode, the Voyager achieves Class AB performance in a compact design, rivaling much larger (and heavier) amplifiers.

The input stage of the new product inherits the architecture of the 610T model, using the ECC83 tube for voltage amplification. The ECC83 output is buffered by bipolar transistors, which allows the amplifier to maximize the power reserve of the input stage and preserve the best sound qualities of the ECC83.

The Revelation 2 Mono Amplifier uses Balanced Bridged technology, and has Line Stage Gain Module input stage found in company's top amps. With 600 W power output into 8 Ohms load this model offers true audiophile experience.

Reference grade mono amp delivers 1,700 W into 8 Ohms load, 3,400 W into 4 ohms, and 6,000 W when two Statement Monos are bridged. With 96 output transistors this amplifier offers incredible characteristics and sound quality.

Olympia Mono Power Amplifier based on 4 x KT88 + 1 x 12AX7 + 1 x 12AU7 tubes uses fully balanced scheme and equipped with unique microprocessor bias control system. 150 W output power can drive even complex loudspeakers.

BRAMA Monoblock Power Amplifier uses Class AB MOSFET output stage and offers 600 W RMS of output power into 4 Ohms load and up to 1,200 W RMS into 2 Ohms loudspeakers.

Following the Reference Preamp, the Swiss company Nagra has introduced the Reference AMP monoblock power amplifiers. The model replaces the well-known Nagra HD AMP and boasts a 25% larger power supply with 2000 VA transformers.

Boulder 1152 is capable of driving almost any speaker system on the market. The amplifier is capable of delivering 350 W per channel at 8 Ohm, 600 Ohm at 4 Ohm and 750 Ohm at 2 Ohm load.

The Fjord Audio P150 mono tube power amplifier from the South Korean company Fjord Audio features an original DFD (Direct Full Difference) circuit and does not use any negative feedback, which provides impressive sound.

The Croatian company Limestone has introduced the Limestone PP1 mono power amplifier, which uses KT88 tubes. The model is housed in an “armor-piercing” case made of 1.5 mm stainless steel. Kerrock decorative panels add exquisite touches and allow the devices to fit into any interior.

The output stage of the NAT Transmitter Evo amplifier can operate in two modes – high power up to 80 W or low power up to a moderate 40 W. Both modes use a directly heated triode in a single-ended connection. With a power of 80 W in a single-ended configuration, it is possible to choose almost any speaker system as a partner - NAT Transmitter EVO is capable of working with speaker systems with an impedance of 2 to 16 Ohms.